esphome:
  name: jiecang-desk-controller # change this!
  friendly_name: Jiecang Desk Controller # change this!
  on_boot:
    # don't touch if you don't know what you're doing!
    priority: 0 # when mostly everything else is done
    then:
      - lambda: "id(my_desk).request_physical_limits();"
      - delay: 0.1s # give controller a chance to handle the response before sending the next command
      - lambda: "id(my_desk).request_limits();"
      - delay: 0.1s
      - lambda: "id(my_desk).request_settings();"

external_components:
  - source:
      type: git
      url: https://github.com/Rocka84/esphome_components/
    components: [ jiecang_desk_controller ]

uart:
  id: uart_bus
  tx_pin: TX
  rx_pin: RX
  baud_rate: 9600

logger:
  baud_rate: 0 # disable logging over uart, required when using the RX/TX pins for the controller

# see full example for more options: https://github.com/Rocka84/esphome_components/blob/master/components/jiecang_desk_controller/example_full.yaml
jiecang_desk_controller:
  id: my_desk
  buttons:
    step_up:
      name: "Step up"
    step_down:
      name: "Step down"
    stop:
      name: "Stop"
    position1:
      name: "Position 1"
    position2:
      name: "Position 2"
    position3:
      name: "Position 3"
    position4:
      name: "Position 4"
  numbers:
    height:
      name: "Height"

# the usual stuff

esp8266:
  board: esp01_1m

wifi:
  ssid: !secret wifi_ssid
  password: !secret wifi_password
  ap:
    ssid: "esphome-desk"
    password: "9ebc6eac0b4e0e26b8d3b955ec660557"

captive_portal:
api:
  encryption:
    key: !secret encryption_key
ota: